1. Store product in an area so as to bring the material to normal room termperature before using.
2. Mix part A and part B together thoroughly being sure to scrape the sides and bottom of the container. Continue mixing for another couple of minutes to insure a homogeneous mixture that is properly mixed. Mix the materials with slow speed mixing equipment or by hand mixing in order to minimize air being whipped into the coating.
3. Make certain that the substrate where the product is to be applied, is clean , sound and free of all laitance, dirt, dust, oil, grease, or foreign contaminants. Properly prime the surface to be coated. Make certain the floor is free of all standing water (we recommend a 24 hour dry out time prior to application).
4. Make certain that the floor temperature and the air temperature as well as any humidity recommendations are within the recommended ranges before applying the product.
5. This product may be applied by roller, brush or spray. Be sure to apply this product at the specified coverage rate or recommended mil thickness. If some air entrapment is encountered, then use an air release roller tool for back rolling prior to the coating tacking off. When applying coatings that are light in color or bright, additional coats of this produt or a primer of the same color may be necessary.
6. Allow sufficient time between coats and remember, as temperatures become lower this product will require additional time to cure.
7. Always check the previous coat for foreign contaminatin (an in some cased for epoxy blushes) before recoating. Roughen and degloss as well as thoroughly cleaning the previous coat before applying additional coats.
8. Take notice of the full cure time and do not open the area to harsh industrial chemical (including water) or abusive use before the full characteristics of the ocating is achieved.

We warrant that our product is manufactured to the specifications as stated here or in other publications. All other information supplied by us is accurate to the best of our knowledge. Such information supplied about our products is not a representation or a warranty. It is supplied on the condition that you shall make your own tests to determine the suitability of our product for your particular purpose. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, REGARDING SUCH OTHER INFORMATION, THE DATA ON WHICH IT IS BASED, OR THE RESULTS YOU WILL OBTAIN FROM ITS USE. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, THAT OUR PRODUCT SHALL BE MERCHANTABLE OR THAT OUR PRODUCT SHALL BE FIT FOR ANY PARTICULAR PURPOSE. NO WARRANTY IS MADE THAT THE USE OF SUCH INFORMATION OR OUR PRODUCT WILL NOT INFRINGE UPON ANY PATENT. We shall have no liability for incidental or consequential damages, direct or indirect. Our liability is limited to the net selling price of our product or the replacement of our product, at our option. Acceptance of delivery of our product means that you have accepted the terms of this warranty whether or not purchase orders or other documents state terms that vary from this warranty. No representative is authorized to make any representation or warranty or assume any other liability on our behalf with any sale of our products. Uncured epoxy resins, polymers and their curing agents may be ALKALINE, TOXIC or BOTH, depending on the particular system. They may cause ALLERGIC REACTIONS or HYPERSENSITVITY REACTIONS. BEFORE USING any material, READ THE MATERIAL SAFETY DATA SHEET AND FOLLOW ALL PRECAUTIONS TO PREVENT BODILY HARM.